Hatco FST-1-MN Bedienungsanleitung PDF herunterladen (Seite 6)

INSTALLATION

Form No.

MNM-0702

Chip Deflector

Floor Panels

Decal-Install on

upper stainless

steel panel.

Install chip deflector in slots located behind upper

door panel.

Figure 5. Set-Up (FDW-1-MN shown)

SET-UP

The Macho Nacho

™

unit comes pre-assembled

and ready for set-up.

1. Remove tape and protective film from all surfaces

of unit.

2. Install the chip deflector inside, behind the upper

door. See Figure 5.

3. Install decals on the upper front and side stainless

steel panels.

Before installing decals, clean the stainless steel side

panels with a non-oily cleaner, such as isopropyl

alcohol (rubbing alcohol). After the cleaned surfaces

have dried, simply remove the protective backing

from the decal and apply to the panel. Any air

pockets or bubbles behind the decal can be removed

by rubbing gently with a soft cloth, working from

the center of the decal towards the outer edges.

WARNING

For safe and proper operation, the unit must be

located at a reasonable distance from combustible

walls and materials. If safe distances are not

maintained, discoloration or combustion could occur.

CAUTION

To prevent injury or damage the unit must be

transported in the upright position. If laid on its side,

all glass surfaces must be secured with tape.

CAUTION

Locate the unit at the proper counter height,

in an area that is convenient for use. The location

should be level to prevent the unit or its contents

from accidentally falling, and strong enough

to support the weight of the unit and food displayed.

CAUTION

Unit is not weatherproof. For safe and proper

operation locate the unit indoors

where the ambient

air temperature is a minimum of 70°F (21°C).

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Hatco FST-1-MN Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern